75L Motor Driven Rubber Kneader
Description of rubber kneader:
The internal mixer of the plastic rubber kneader is suitable for the rubber, plastic and chemical industries. Mixing with most suita bler applications: EVA, rubber, TPR, shoe soles, rubber rollers, hoses, belts, sponges, vibration insulators, elastic ropes, sealing materials, tires, strips, master batches, pigments, inks, conductive rubber Components, chemical industry compounds.
|Total volume (L)
|Working volume (L)
|Motor power (KW)
|Tilting motor power (KW)
|Tilting angle (°)
|Rotor speed (r/min)
|Pressure of compressed air (MPa)
|Capacity of compressed air (m3/min)
|Pressure of cooling water (MPa)
Advantages of rubber kneader:
Intensive kneading and dispersion of high viscosity products
Shorten processing time and improve product quality
The minimum processing capacity is 25% of the total container capacity
Infinitely variable speed by inverter
Can be automated according to customer requirements
All metal parts in contact with the product are made of AISI 316L/316Ti stainless steel
The seal is made of high-quality materials
Application fields of rubber kneader:
Hot melt glue
Hard metal compounds
1. Regularly check the insulation effect of each line, and always pay attention to the warning content on the machine warning sign.
2. When the moving parts and mixing chamber are blocked, do not put them inside by hand or iron rods, but handle them carefully with plastic rods.
3. When touching high temperature parts, please be careful not to get burned.
4. When the leaked powder or the sealing ring makes a harsh sound, firstly loosen the four nuts evenly, then screw them in some, then add some lubricating oil or engine oil into the rotor gap of the mixing chamber, and then run idly 3 -At the same time, use a hammer to gently tap the outer periphery of the spring side seal ring. If the powder leaks, adjust the tightness of each spring. If the sealing ring is pressed down and the side chamber of the mixing chamber sinks, when it is closed, the internal sealing ring will wear out and need to be replaced again.
Refer to the instruction manual for the method of replacing the seal ring.
5. Special attention: check the oil level and lubrication status of gear oil, engine oil and grease before starting each day. Note that the oil level of the triple oil cup should not be less than half a day, and regularly observe the changes of the triple oil level. If the oil consumption or the oil consumption is too high (adjust the knob of the triple switch), replace the gear oil of the new machine within half a year at the latest, and add lubricating parts to the movable parts at least once a week, and the oil must not exceed half of the oil glass. Otherwise it will cause oil leakage.
6. When the machine fails, the machine will stop for the first time.
Unrelated personnel are not allowed to perform any operations, notify and wait for your mechanic to inspect and repair.